Differences

This shows you the differences between two versions of the page.

--- userdoc:board_qotom_q190g4n-s07 [2020/08/30 10:52] – mkeuter
+++ userdoc:board_qotom_q190g4n-s07 [2025/01/06 16:35] (current) – abelbeck
@@ Line 3: / Line 3: @@
 !!Note: AstLinux 1.2.10 or later is required!!
-**Board Specifications:**  [[http://doc.astlinux-project.org/_media/userdoc:qotom-q190g4n-s07-motherboard-manual.pdf|Q1900G4 Nano Motherboard]]
+**Board Specifications:**  [[https://doc.astlinux-project.org/_media/userdoc:qotom-q190g4n-s07-motherboard-manual.pdf|Q1900G4 Nano Motherboard]]
 **Vendor:** [[http://www.qotom.net/product/36.html|Product Page]] ((there is also a nearly identical [[http://www.qotom.net/product/35.html|Q190G4U]] version in a slightly different design))
@@ Line 80: / Line 80: @@
 If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the "Boot" page.\\
 Or you can choose a temporary Boot-Device at the „Save & Exit“ tab under „Boot Override“ at the bottom (instead of a Boot-Menu).
+!!Update:!! To activate the boot menu, press F11 (or F7 on some models).
 **Photos:**
@@ Line 89: / Line 91: @@
 {{:userdoc:qotom-q190g4n-s07-inside.jpg?nolink|Inside}}
-**Qotom Q190G4U**
+**Qotom Q190G4U (alternative model)**
-{{:userdoc:qotom-q190g4u-s01-back.jpg?nolink|Q190G4U Back}}
+{{:userdoc:qotom-q190g4u-s01-back.jpg?nolink&650|Q190G4U Back}}
-{{:userdoc:qotom-q190g4u-s01-back.jpg?nolink&600|}}
 \\