This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
userdoc:tt_wan_failover [2021/01/19 13:13] mkeuter [AVM FRITZ!Box 6820v3 LTE as LTE Router] |
userdoc:tt_wan_failover [2021/01/19 13:15] (current) mkeuter [AVM FRITZ!Box 6820v3 LTE as LTE Router] |
[[https://en.avm.de/products/fritzbox/fritzbox-6820-lte/|Product Info]] | [[https://en.avm.de/products/fritzbox/fritzbox-6820-lte/|Product Info]] |
| |
* on the homepage click at the 3 dots in the upper right corner and enable "Advanced View" | * on the FRITZ!Box overview page click on the 3 dots in the upper right corner and enable "Advanced View" |
* under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the "IPv4 Address" (to e.g. ''192.168.5.1''), cause every FRITZ!Box by default uses ''192.168.178.1'' and that can lead to problems when using VPNs or other FRITZ!Boxes. | * under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the "IPv4 Address" (to e.g. ''192.168.5.1''), cause every FRITZ!Box by default uses ''192.168.178.1'' and that can lead to problems when using VPNs or other FRITZ!Boxes. |
* setup your AstLinux Failover interface with a static address from the same network (best below ''.20'' because of DHCP) e.g. ''192.168.5.11'' and reboot AstLinux. | * setup your AstLinux Failover interface with a static address from the same network (best below ''.20'' because of DHCP) e.g. ''192.168.5.11'' and reboot AstLinux. |
* under "Internet/Permit Access" click "Add Device for Sharing" and enable the "Exposed Host" function for your AstLinux Failover interface. | * under "Internet/Permit Access" click "Add Device for Sharing" and enable the "Exposed Host" function for your AstLinux Failover interface. |