userdoc:board_jetway_nf9hql-525

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
userdoc:board_jetway_nf9hql-525 [2015/05/25 10:10] – droemeluserdoc:board_jetway_nf9hql-525 [2019/07/25 03:36] (current) – abelbeck
Line 7: Line 7:
 **AstLinux Board Type:** **AstLinux Board Type:**
  
-  * "geni586-serial" (19200 baud serial console)+  * "genx86_64-serial" (Serial Console: ''19200'' baud for AstLinux 1.2.10 and earlier, ''115200'' baud for AstLinux 1.3.0 and later)
  
 **Complete System Recommended Options:** **Complete System Recommended Options:**
Line 25: Line 25:
  
 **Total System Power (no PCIe Expansion Card):**  15 Watts when idle. **Total System Power (no PCIe Expansion Card):**  15 Watts when idle.
 +
 +**Performance:**  ~50 secs. (Single-core test, lower is better)
 +
 +  time ( echo "scale=3456; 4*a(1)" | bc -l )
  
 **Configuration:** **Configuration:**
Line 88: Line 92:
  
 First, configure your serial terminal program to support ANSI color and 115200 baud.  If you are using minicom be sure to add the ' ''-c on'' ' option to the minicom command line, otherwise the ANSI colors will not be distinguishable in the BIOS Setup screen. First, configure your serial terminal program to support ANSI color and 115200 baud.  If you are using minicom be sure to add the ' ''-c on'' ' option to the minicom command line, otherwise the ANSI colors will not be distinguishable in the BIOS Setup screen.
 +
 +!!Note ->!! Leave ''Serial Port Mode -> 115200 8,n,1'' for AstLinux 1.3.0 and later.
  
 Second, on startup type F4 (<ESC>OS) to enter the BIOS Setup, go to the "Integrated Peripherals" -> "Remote Access Configuration" .  Make the following changes... Second, on startup type F4 (<ESC>OS) to enter the BIOS Setup, go to the "Integrated Peripherals" -> "Remote Access Configuration" .  Make the following changes...
Line 105: Line 111:
 The above example slows the CPU fan for normal operation and reduces the noise. The above example slows the CPU fan for normal operation and reduces the noise.
  
-Finally, save the above BIOS changes, reboot, and reconfigure you serial terminal program to 19200 baud, this will match what AstLinux expects.+Finally, save the above BIOS changes, reboot, and reconfigure you serial terminal program if you changed the baud rate.
  
 **Photos:** **Photos:**
  • userdoc/board_jetway_nf9hql-525.1432548636.txt.gz
  • Last modified: 2015/05/25 10:10
  • by droemel