Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| userdoc:tt-bridges [2023/07/27 16:06] – mkeuter | userdoc:tt-bridges [2023/07/27 16:33] (current) – mkeuter | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Network-Bridges (BRIDGE0) ====== | ====== Network-Bridges (BRIDGE0) ====== | ||
| + | |||
| + | !!Note:!! This is outdated documentation, | ||
| + | |||
| + | ---- | ||
| !!When you setup a software network bridge in AstLinux, you need to be careful to not lock out your network connection: | !!When you setup a software network bridge in AstLinux, you need to be careful to not lock out your network connection: | ||
| - | **Q:** When I enter | + | **Q:** When I enter |
| - | BRIDGE0=" | + | |
| - | in the user.conf and reboot, why is then '' | + | BRIDGE0=" |
| + | |||
| + | in the '' | ||
| **A:** If eth0 was on the external interface, you would also need to set (temporarily): | **A:** If eth0 was on the external interface, you would also need to set (temporarily): | ||