This is an old revision of the document!
Hyper-V
Note: AstLinux 1.2.10 or later is required
VM Host Specifications: Hyper-V
AstLinux Board Type:
- “genx86_64-vm” (VGA video console)
VM Guest Recommended Options:
- Memory: 512 to 1024 MB
- CPU: 2 Processor Cores
- Virtual Storage: 4 to 8 GB
- Network: Bridged Interface
Configuration:
… TBD …
Finally, configure AstLinux using the normal setup.
Tip -> Note the “IPv4 Address:” on the screen and access the VM with SSH or an HTTPS browser on the same network.
After persistent storage is configured, edit /etc/rc.modules
file and uncomment hv_netvsc
:
## These modules get modprobe'd when the system starts up. rtc ## Comment out any modules you don't need. ## ## Ethernet support ## Virtual first, then Emulated hv_netvsc virtio-pci vmxnet3 pcnet32 e1000 e1000e 8139too