userdoc:board_jetway_nf99fl-525

This is an old revision of the document!


Jetway NF99FL-525 Dual Core Atom

Note: Requires AstLinux 1.x

AstLinux Board Type:

  • “geni586” (VGA video console)
  • “geni586-serial” (19200 baud serial console)

Complete System Recommended Options:

  • Daughterboard: Optional
  • Memory: 204-pin DDR3 1333 SO-DIMM 2GB (or 2x 1GB sticks)
  • Flash Drive: Emphase Industrial S1 SATA Flash Module 2 GB
  • Case:
    • No PCI Expansion Card Support
      • M350 Universal Mini-ITX Case
      • AC Adapter (brick): AC Power Adapter 60W, 12V, 5A
      • DC-DC Power Converter (20-pin ATX Power): PicoPSU-80, 80 W, 12 V
      • Fan (optional): 40x40x10mm or 40x40x20mm (Noise < 25 dBA)
    • With PCI Expansion Card Support
      • Jetway Case JC-11x-B Series (or similar)
      • AC Adapter (brick) is included, Internal ATX Power Supply
      • 2 Fans are included, CF-Reader (USB) included (optional)
      • Riser card for 2 PCI slots is included

Configuration:

/mnt/kd/rc.conf.d/user.conf

SENSEMODS="f71882fg"

ALERT_SOUNDS="startup shutdown"  # Optional Sounds


/mnt/kd/sensors.conf

# libsensors configuration file
# -----------------------------
# Jetway NF96FL-525/NF99FL-525 Dual Core Atom

chip "f71808e-*" "f71808a-*" "f71862fg-*" "f71869-*" "f71869a-*" "f71882fg-*" \
     "f71889fg-*" "f71889ed-*" "f71889a-*"

ignore in1
ignore in2
ignore in3
ignore in4
ignore in5
ignore in6

# Comment-out installed fan(s)
#ignore fan1
ignore fan2
ignore fan3

label in0 "+3.3V"
label in7 "3VSB"
label in8 "Vbat"

label fan1 "CPU Fan"
label fan2 "SYS Fan1"
label fan3 "SYS Fan2"

label temp1 "CPU Temp"
label temp2 "SYS Temp1"
label temp3 "SYS Temp2"

compute in0  @*2, @/2
compute in7  @*2, @/2
compute in8  @*2, @/2


If your system has one or more fans, you may want to enable Fan Smart Mode in the BIOS. This will automatically vary the fan speed according to it's corresponding temperature sensor. In the BIOS Setup, go to the “PC Health Status” → “Smart FAN Configurations”

Fan BIOS

In this example, the fan runs at 50% of full speed at 45 C and below, then linearly ramps up to 100% full speed at 75 C and above. For louder/faster 40x40x20mm fans, values of 095(Full),065(Idle),025(%) slows the fan for normal operation and reduces the noise.

Photos:

Side 1

Side 2

Back

  • userdoc/board_jetway_nf99fl-525.1340908433.txt.gz
  • Last modified: 2012/06/28 13:33
  • by abelbeck