Differences

This shows you the differences between two versions of the page.

--- userdoc:board_jetway_jbc430u941 [2020/06/30 14:20]
abelbeck
+++ userdoc:board_jetway_jbc430u941 [2022/05/20 17:10] (current)
abelbeck
@@ Line 2: / Line 2: @@
 !!Note: AstLinux 1.3.0 or later is required!!
-!!Tip ->!! Also consider the similar **[[userdoc:board_protectli_fw4b|Protectli FW4B]]**
 **Board Specifications:**  [[https://www.jetwaycomputer.com/JBC430U941.html|JBC430U941 / HBJC430U941]] [[https://www.jetwaycomputer.com/spec/JBC430U941.pdf|Datasheet]]
@@ Line 19: / Line 17: @@
 **Total System Power (no HDMI connection):**  6.5 Watts when idle.
-**Performance:**  34.9 secs. (Single-core test, lower is better)
+**Performance:**  24.9 secs. (Single-core test, lower is better)
   time ( echo "scale=3456; 4*a(1)" | bc -l )
@@ Line 52: / Line 50: @@
 \\
-**BIOS Setup for Boot Option Filter (non-UEFI):**
+**BIOS Setup for Boot OS Selection (non-UEFI):**
-While in the BIOS Setup as above, check to make sure Legacy only boot is enabled, go to the "Advanced" -> "CSM Configuration" menu...
+While in the BIOS Setup as above, to enable Legacy boot, go to the "Advanced" -> "CSM Configuration" menu...
   * ''Boot Option Filter -> Legacy Only''
+\\
+**BIOS Setup for Boot OS Selection (UEFI):**
+!!UEFI Boot requires AstLinux 1.4.6 or later!! - additionally RUNNIX 0.6.10 or later is needed.
+While in the BIOS Setup as above, to enable UEFI boot, go to the "Advanced" -> "CSM configuration" menu...
+  * ''Boot option filter -> UEFI Only''
 \\