userdoc:board_jetway_jbc430u941

Jetway JBC430U941 Quad Core Fanless Celeron N3160

Note: AstLinux 1.3.0 or later is required

Board Specifications: JBC430U941 / HBJC430U941 Datasheet

AstLinux Board Type:

  • “genx86_64” (Video Console: HDMI)
  • “genx86_64-serial” (Serial Console: 115200 baud)

Complete System Recommended Options:

  • Memory: 204-pin DDR3L-1600 (1.35V) SO-DIMM 4GB
  • Storage: M.2 type 2242 SATA (Transcend 32GB TS32GMTS400S or similar)

Total System Power (no HDMI connection): 6.5 Watts when idle.

Performance: 24.9 secs. (Single-core test, lower is better)

time ( echo "scale=3456; 4*a(1)" | bc -l )

Configuration:

/mnt/kd/rc.conf.d/user.conf

SENSEMODS="coretemp"

ALERT_SOUNDS="startup shutdown"  # Optional Sounds
ALERT_SOUNDS_OCTAVE="1"


/mnt/kd/sensors.conf

# libsensors configuration file
# -----------------------------
# Jetway CPU N3160

# coretemp CPU sensor


BIOS Setup for Restore AC Power Loss:

The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU. As such the Jetway N3160 does not automatically power on after a power failure. Obviously this feature needs to be disabled.

On startup (quickly) press the <ESC> key to enter the BIOS Setup, go to the “Chipset” → “South Bridge” . Make the following changes…

  • System State after Power Failure → Always On


BIOS Setup for Boot OS Selection (non-UEFI):

While in the BIOS Setup as above, to enable Legacy boot, go to the “Advanced” → “CSM Configuration” menu…

  • Boot Option Filter → Legacy Only


BIOS Setup for Boot OS Selection (UEFI):

UEFI Boot requires AstLinux 1.4.6 or later - additionally RUNNIX 0.6.10 or later is needed.

While in the BIOS Setup as above, to enable UEFI boot, go to the “Advanced” → “CSM configuration” menu…

  • Boot option filter → UEFI Only


(Optional) BIOS Setup for Console Redirection:

If you are using a serial console, you may want to optionally enable Console Redirection for the BIOS configuration.

Go to the “Advanced” → “Serial Port Console Redirection” menu…

  • COM1
  • Console Redirection → Enabled
  • Console Redirection Settings
    • Terminal Type → VT100+
    • Redirect After BIOS POST → BootLoader


Save the above BIOS changes, reboot.

Photos:

Banana View
Small 5.1 x 4.3 inch (129 x 109 mm) footprint. Banana not included.

Network

Front

Inside


  • userdoc/board_jetway_jbc430u941.txt
  • Last modified: 2022/05/20 17:10
  • by abelbeck