This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
|
userdoc:tt_edgerouter-x [2022/08/29 07:17]
mkeuter |
userdoc:tt_edgerouter-x [2022/08/29 07:23] (current)
mkeuter [Flash ER-X with OpenWrt using AstLinux] |
| With the "System Load Linux to SDRAM via TFTP" chosen, you need to specify two IP addresses and the name of the TFTP filename ''openwrt.bin'', as show above. | With the "System Load Linux to SDRAM via TFTP" chosen, you need to specify two IP addresses and the name of the TFTP filename ''openwrt.bin'', as show above. |
| |
| !!Note:!! Some OpenWRT devices work exclusively with ''192.168.1.1'' + ''192.168.1.2'' as the device + server IP addresses! ((use e.g.\\ ''ifconfig eth1:1 192.168.1.2 netmask 255.255.255.0 up''\\ to add an additional virtual address to the server)) | !!Note ->!! Some OpenWRT devices work exclusively with ''192.168.1.1'' + ''192.168.1.2'' as the device + server IP addresses! ((use e.g.\\ ''ifconfig eth1:1 192.168.1.2 netmask 255.255.255.0 up''\\ to add an additional virtual address to the server)) |
| |
| Type RETURN and the ER-X should reboot into the factory initramfs-kernel of OpenWrt. After the dmesg logs appear to stop, type RETURN again, you should see a login as shown below: | Type RETURN and the ER-X should reboot into the factory initramfs-kernel of OpenWrt. After the dmesg logs appear to stop, type RETURN again, you should see a login as shown below: |