Differences

This shows you the differences between two versions of the page.

--- userdoc:tt_asterisk-fop2-install [2015/10/31 12:06] – [Install FOP2 via Web Interface] droemel
+++ userdoc:tt_asterisk-fop2-install [2015/10/31 12:09] (current) – [Install FOP2 via CLI] droemel
@@ Line 28: / Line 28: @@
   write = all
   writetimeout = 1000
-  eventfilter=!Event: RTCPSent
+  eventfilter=!Event: RTCP*
-  eventfilter=!Event: RTCPReceived
   eventfilter=!Event: VarSet
   eventfilter=!Event: Cdr
+  eventfilter=!Event: DTMF
+  eventfilter=!Event: AGIExec
   eventfilter=!Event: ExtensionStatus
   eventfilter=!Event: ChannelUpdate
@@ Line 74: / Line 75: @@
 will automatically stop any running daemon and remove the FOP2 code.  The ''/mnt/kd/fop2/'' directory is left alone, so later enabling (Upgrade/Install) fop2 picks up where you left off.
 ===== Install FOP2 via CLI =====
@@ Line 96: / Line 96: @@
   write = all
   writetimeout = 1000
-  eventfilter=!Event: RTCPSent
+  eventfilter=!Event: RTCP*
-  eventfilter=!Event: RTCPReceived
   eventfilter=!Event: VarSet
   eventfilter=!Event: Cdr
+  eventfilter=!Event: DTMF
+  eventfilter=!Event: AGIExec
   eventfilter=!Event: ExtensionStatus
   eventfilter=!Event: ChannelUpdate
+  eventfilter=!Event: ChallengeSent
+  eventfilter=!Event: SuccessfulAuth
+  eventfilter=!Event: HangupRequest
+  eventfilter=!Event: SoftHangupRequest
+  eventfilter=!Event: NewAccountCode
+  eventfilter=!Event: MusicOnHold
+  eventfilter=!Event: LocalBridge
 Also, Edit the ''/etc/asterisk/sip.conf'' file and enable callevents: