userdoc:board_qotom_q750g5

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
userdoc:board_qotom_q750g5 [2022/04/22 10:02]
mkeuter
userdoc:board_qotom_q750g5 [2022/04/23 05:31] (current)
mkeuter
Line 9: Line 9:
 **Complete System Recommended Options:** **Complete System Recommended Options:**
  
-  * Memory: DDR4 2GB+  * Memory: 260-pin DDR4 SO-DIMM 4GB
   * Storage: mSATA SSD (PC Engines msata16 “Phison” or similar)   * Storage: mSATA SSD (PC Engines msata16 “Phison” or similar)
  
Line 24: Line 24:
  
   SENSEMODS="coretemp"   SENSEMODS="coretemp"
 +  
 +  ALERT_SOUNDS="startup shutdown"  # Optional Sounds
 +  #ALERT_SOUNDS_OCTAVE="1"
      
   ## Optional USB TTY serial login   ## Optional USB TTY serial login
Line 59: Line 62:
 **BIOS Setup for Boot OS Selection (non-UEFI):** **BIOS Setup for Boot OS Selection (non-UEFI):**
  
-While in the BIOS Setup as above, check to make sure Legacy boot is enabled, go to the "Advanced" -> "CSM configuration" menu...+While in the BIOS Setup as above, to enable Legacy boot, go to the "Advanced" -> "CSM configuration" menu...
  
   * ''Boot option filter -> Legacy only''   * ''Boot option filter -> Legacy only''
Line 67: Line 70:
 {{:userdoc:qotom-q750g5-bios-legacy-boot.png?nolink&600|BIOS Legacy Boot}} {{:userdoc:qotom-q750g5-bios-legacy-boot.png?nolink&600|BIOS Legacy Boot}}
  
-**Other BIOS Settings**+\\ 
 +**BIOS Setup for Boot OS Selection (UEFI):**
  
-"Advanced" -> "Trusted Computing" -> "Security Device Support" => "[Disable]"+!!UEFI Boot requires AstLinux 1.4.6 or later!! additionally RUNNIX 0.6.10 or later is needed.
  
-"Advanced" -> "CSM Configuration-> "Boot option filter" => "[UEFI only]" (for UEFI Mode) - !!Supported since AstLinux 1.4.6!! - also RUNNIX 0.6.10 is needed!+While in the BIOS Setup as above, to enable UEFI boot, go to the "Advanced" -> "CSM configurationmenu...
  
 +  * ''Boot option filter -> UEFI only''
 +
 +\\
 +**Other BIOS Settings**
 +
 +"Advanced" -> "Trusted Computing" -> "Security Device Support" => "[Disable]"
  
 Save the above BIOS changes, reboot. Save the above BIOS changes, reboot.
  
 If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the "Boot" page.\\  If the mSATA was pre-installed (with e.g. PFSense) you also need to setup the Boot Priorities for the USB stick correctly on the "Boot" page.\\ 
-Or you can choose a temporary Boot-Device at the Save & Exit“ tab under Boot Override“ at the bottom (instead of a Boot-Menu).+Or you can choose a temporary Boot-Device at the "Save & Exittab under "Boot Overrideat the bottom (instead of a Boot-Menu).
  
 **Photos:** **Photos:**
  
 +{{:userdoc:qotom-q750g5-network.jpg?nolink|Network}}
 +
 +{{:userdoc:qotom-q750g5-front.jpg?nolink|Front}}
 +
 +{{:userdoc:qotom-q750g5-inside.jpg?nolink|Inside}}
  
 \\ \\
  • userdoc/board_qotom_q750g5.1650639742.txt.gz
  • Last modified: 2022/04/22 10:02
  • by mkeuter