Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
userdoc:board_jetway_nf9hg-2930 [2017/05/18 17:18] droemel |
userdoc:board_jetway_nf9hg-2930 [2019/07/24 21:14] (current) abelbeck |
||
---|---|---|---|
Line 7: | Line 7: | ||
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
- | * " | + | * " |
- | * " | + | * " |
**Complete System Recommended Options:** | **Complete System Recommended Options:** | ||
Line 19: | Line 19: | ||
* AC Adapter (brick): AC Power Adapter 36W, 12V, 3A or 60W, 12V, 5A (5,5*2,5mm) | * AC Adapter (brick): AC Power Adapter 36W, 12V, 3A or 60W, 12V, 5A (5,5*2,5mm) | ||
* __With PCIe Expansion Card Support__ | * __With PCIe Expansion Card Support__ | ||
- | * Jetway Case [[http:// | + | * [[http:// |
* AC Adapter (brick) is included, Internal ATX Power Supply not used | * AC Adapter (brick) is included, Internal ATX Power Supply not used | ||
* __1U 19" Rack-mounted chassis__ | * __1U 19" Rack-mounted chassis__ | ||
Line 26: | Line 26: | ||
**Total System Power (no PCIe Expansion Card): | **Total System Power (no PCIe Expansion Card): | ||
- | **Performance: | + | **Performance: |
- | | + | time ( echo " |
- | | + | |
**Configuration: | **Configuration: | ||
Line 54: | Line 53: | ||
Initially you must use the included VGA cable((in some countries (e.g. Germany) you may need to order the VGA header cable separately)) to connect to the board' | Initially you must use the included VGA cable((in some countries (e.g. Germany) you may need to order the VGA header cable separately)) to connect to the board' | ||
+ | |||
+ | !!Note ->!! Leave '' | ||
Using the VGA connection, enter the BIOS Setup, go to the " | Using the VGA connection, enter the BIOS Setup, go to the " | ||
Line 70: | Line 71: | ||
Save the above BIOS changes, reboot. | Save the above BIOS changes, reboot. | ||
- | Later to access the BIOS, configure your serial terminal program to support ANSI color and 19200 baud. If you are using minicom be sure to add the ' '' | + | Later to access the BIOS, configure your serial terminal program to support ANSI color and the matching |
\\ | \\ |