Differences

This shows you the differences between two versions of the page.

--- userdoc:board_jetway_jbc430u941 [2019/11/18 15:47]
abelbeck
+++ userdoc:board_jetway_jbc430u941 [2022/05/07 10:13]
abelbeck
@@ Line 3: / Line 3: @@
 !!Note: AstLinux 1.3.0 or later is required!!
-**Board Specifications:**  [[https://www.jetwaycomputer.com/spec/JBC430U941.pdf|JBC430U941 / HBJC430U941]]
+**Board Specifications:**  [[https://www.jetwaycomputer.com/JBC430U941.html|JBC430U941 / HBJC430U941]] [[https://www.jetwaycomputer.com/spec/JBC430U941.pdf|Datasheet]]
 **AstLinux Board Type:**
@@ Line 17: / Line 17: @@
 **Total System Power (no HDMI connection):**  6.5 Watts when idle.
-**Performance:**  34.9 secs. (Single-core test, lower is better)
+**Performance:**  24.9 secs. (Single-core test, lower is better)
   time ( echo "scale=3456; 4*a(1)" | bc -l )
@@ Line 43: / Line 43: @@
 **BIOS Setup for Restore AC Power Loss:**
-The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU.  As such the Qotom Q530G6 does not automatically power on after a power failure.  Obviously this //feature// needs to be disabled.
+The Energy-Related Products Directive (ERP) is the European Commission Directive required for products sold and exported to the EU.  As such the Jetway N3160 does not automatically power on after a power failure.  Obviously this //feature// needs to be disabled.
 On startup (quickly) press the ''<ESC>'' key to enter the BIOS Setup, go to the "Chipset" -> "South Bridge" .  Make the following changes...
@@ Line 50: / Line 50: @@
 \\
-**BIOS Setup for Boot Option Filter (non-UEFI):**
+**BIOS Setup for Boot OS Selection (non-UEFI):**
-While in the BIOS Setup as above, check to make sure Legacy only boot is enabled, go to the "Advanced" -> "CSM Configuration" menu...
+While in the BIOS Setup as above, to enable Legacy boot, go to the "Advanced" -> "CSM Configuration" menu...
   * ''Boot Option Filter -> Legacy Only''
+\\
+**BIOS Setup for Boot OS Selection (UEFI):**
+!!UEFI Boot requires AstLinux 1.4.6 or later!! - additionally RUNNIX 0.6.10 or later is needed.
+While in the BIOS Setup as above, to enable UEFI boot, go to the "Advanced" -> "CSM configuration" menu...
+  * ''Boot option filter -> UEFI only''
 \\
@@ Line 76: / Line 85: @@
 {{:userdoc:jetway_jbc430u941-banana.jpg?nolink|Banana View}}
 \\
-Small 5 x 4.2 inch (12.7 x 10.7 cm) footprint. //Banana not included.//
+Small 5.1 x 4.3 inch (129 x 109 mm) footprint. //Banana not included.//
 {{:userdoc:jetway_jbc430u941-network.jpg?nolink|Network}}