Differences

This shows you the differences between two versions of the page.

--- userdoc:board_jetway_jbc373f38w [2013/05/02 04:32] – abelbeck
+++ userdoc:board_jetway_jbc373f38w [2019/07/25 03:43] (current) – abelbeck
@@ Line 2: / Line 2: @@
 !!Note: Requires AstLinux 1.x!!
+!!Note:!! **Not Recommended!**  This appliance has been failing (multiple reports) after 3-5 years of use, presumably heat related.
 This barebone appliance is also known by the Jetway Part No: HBJC373F38 / HBJC373F38W
@@ Line 9: / Line 11: @@
 **AstLinux Board Type:**
-  * "geni586" (VGA video console)
+  * "genx86_64" (Video Console: VGA)
-  * "geni586-serial" (19200 baud serial console)
+  * "genx86_64-serial" (Serial Console: ''19200'' baud for AstLinux 1.2.10 and earlier, ''115200'' baud for AstLinux 1.3.0 and later)
 **Complete System Recommended Options:**
@@ Line 26: / Line 28: @@
 **Total System Power:**  15 Watts when idle.
+**Performance:**  ~50 secs. (Single-core test, lower is better)
+  time ( echo "scale=3456; 4*a(1)" | bc -l )
 **Configuration:**
@@ Line 83: / Line 89: @@
 **Serial Console COM Port:**
-If the board type of "geni586-serial" is used, you can change the serial console from the default, rear COM port to the front panel COM port.  From the CLI issue the following command:
+If the board type of "genx86_64-serial" is used, you can change the serial console from the default, rear COM port to the front panel COM port.  From the CLI issue the following command:
-  setconsole-speed-tty 19200 ttyS1
+  setconsole-speed-tty 115200 ttyS1
 Revert back to the default rear COM port with the command:
@@ Line 120: / Line 126: @@
 \\