This is an old revision of the document!
Because Astlinux has been created to fit into as small an installation as possible, a full version of Perl is not included. This means that the Sangoma utility wancfg
, which configures Sangoma telephony cards, will not run. The configuration files must therefore be created manually.
Remember that Astlinux stores the majority of its configuration files in a different location to where vanilla Asterisk installations store theirs, so use the locations listed below.
Here are sample Wanpipe configuration files (for a Sangoma A101u in a Soekris net5501 connecting to a US T1). They will need to be customized to fit your own environment.
/mnt/kd/wanpipe/wanpipe1.conf
:
#================================================ # WANPIPE1 Configuration File #================================================ [devices] wanpipe1 = WAN_AFT, Comment [interfaces] w1g1 = wanpipe1, , TDM_VOICE, Comment [wanpipe1] CARD_TYPE = AFT S514CPU = A CommPort = PRI AUTO_PCISLOT = NO PCISLOT = 14 ; } get these values via the command 'wanrouter hwprobe' PCIBUS = 0 ; } FE_MEDIA = T1 FE_LCODE = B8ZS FE_FRAME = ESF FE_LINE = 1 TE_CLOCK = NORMAL TE_REF_CLOCK = 0 ACTIVE_CH = ALL TE_HIGHIMPEDANCE = NO LBO = 0-110FT FE_TXTRISTATE = NO MTU = 1500 UDPPORT = 0 TTL = 255 IGNORE_FRONT_END = NO TDMV_SPAN = 1 TDMV_DCHAN = 24 [w1g1] ACTIVE_CH = ALL TDMV_ECHO_OFF = NO
/mnt/kd/dahdi/system.conf
:
span=1,0,0,esf,b8zs # Configuration for T1 trunk # channel 1-23 data channels bchan=1-23 echocanceller=mg2,1-23 # channel 24 control dchan=24
Add this to the end of /mnt/kd/asterisk/chan_dahdi.conf
:
context=internal switchtype=national signalling = pri_net group = 1,24 channel => 1-23