Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:upgrade-0.7 [2011/11/29 17:37] abelbeck |
userdoc:upgrade-0.7 [2015/12/20 15:40] abelbeck [Upgrade from 0.7.x to 1.0.x] |
||
---|---|---|---|
Line 2: | Line 2: | ||
====== Upgrade from 0.7.x to 1.0.x ====== | ====== Upgrade from 0.7.x to 1.0.x ====== | ||
- | !!**NOTICE: AstLinux 1.0.0 is not available yet!**!! | + | Please read [[http:// |
- | + | ||
- | Please read [[http://astlinux.svn.sourceforge.net/viewvc/astlinux/branches/ | + | |
It is very important to understand that while AstLinux 0.7.x uses the runnix-0.3 bootloader, AstLinux 1.0.x requires the runnix-0.4 bootloader. | It is very important to understand that while AstLinux 0.7.x uses the runnix-0.3 bootloader, AstLinux 1.0.x requires the runnix-0.4 bootloader. | ||
- | If you normally | + | If you ever use the Web Interface, follow the Web Interface instructions |
Follow the steps below, should an error occur, **don' | Follow the steps below, should an error occur, **don' | ||
- | |||
===== Using the Web Interface: ===== | ===== Using the Web Interface: ===== | ||
Line 17: | Line 14: | ||
You must have either console or SSH access to your AstLinux box to perform this upgrade. | You must have either console or SSH access to your AstLinux box to perform this upgrade. | ||
- | Browse | + | First, browse |
(assuming your Astlinux device is called pbx) | (assuming your Astlinux device is called pbx) | ||
Line 28: | Line 25: | ||
{{: | {{: | ||
- | Save changes by clicking {{: | + | save changes by clicking {{: |
Line 41: | Line 38: | ||
{{: | {{: | ||
- | If successful, don't reboot yet, **from the Command Line Interface**, | + | If successful, |
upgrade-RUNNIX-image check http:// | upgrade-RUNNIX-image check http:// | ||
Line 57: | Line 54: | ||
===== Command Line Interface (CLI): ===== | ===== Command Line Interface (CLI): ===== | ||
- | First, upgrade AstLinux Firmware (Remove | + | First, upgrade AstLinux Firmware (Replace |
upgrade-run-image check http:// | upgrade-run-image check http:// | ||
Line 75: | Line 72: | ||
reboot | reboot | ||
+ | \\ | ||
+ | ---- | ||
+ | \\ | ||
+ | In case something went wrong, you can find help **[[userdoc: |