Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:upgrade-0.7 [2011/11/29 16:06] abelbeck |
userdoc:upgrade-0.7 [2014/07/27 10:56] dhartman [Command Line Interface (CLI):] |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
====== Upgrade from 0.7.x to 1.0.x ====== | ====== Upgrade from 0.7.x to 1.0.x ====== | ||
- | |||
- | !!NOTICE: AstLinux 1.0.0 is not available yet!! | ||
Please read [[http:// | Please read [[http:// | ||
It is very important to understand that while AstLinux 0.7.x uses the runnix-0.3 bootloader, AstLinux 1.0.x requires the runnix-0.4 bootloader. | It is very important to understand that while AstLinux 0.7.x uses the runnix-0.3 bootloader, AstLinux 1.0.x requires the runnix-0.4 bootloader. | ||
+ | |||
+ | If you ever use the Web Interface, follow the Web Interface instructions here so the Prefs Tab gets changed properly. | ||
Follow the steps below, should an error occur, **don' | Follow the steps below, should an error occur, **don' | ||
Line 15: | Line 15: | ||
You must have either console or SSH access to your AstLinux box to perform this upgrade. | You must have either console or SSH access to your AstLinux box to perform this upgrade. | ||
- | Browse | + | First, browse |
(assuming your Astlinux device is called pbx) | (assuming your Astlinux device is called pbx) | ||
Line 26: | Line 26: | ||
{{: | {{: | ||
+ | save changes by clicking {{: | ||
- | Browse | + | |
+ | Next, browse | ||
https:// | https:// | ||
+ | Check for new firmware:\\ | ||
+ | {{: | ||
- | Next, from the Command Line Interface, upgrade RUNNIX: | + | If new firmware is available, upgrade firmware: |
+ | {{: | ||
+ | |||
+ | If successful, !!don' | ||
upgrade-RUNNIX-image check http:// | upgrade-RUNNIX-image check http:// | ||
Line 39: | Line 46: | ||
upgrade-RUNNIX-image upgrade http:// | upgrade-RUNNIX-image upgrade http:// | ||
- | Finally, if successful, Reboot, either from the Web Interface or CLI: | + | Finally, if successful, Reboot, either from the Web Interface or CLI:\\ |
+ | {{: | ||
+ | |||
+ | Or | ||
reboot | reboot | ||
Line 45: | Line 55: | ||
===== Command Line Interface (CLI): ===== | ===== Command Line Interface (CLI): ===== | ||
- | First, upgrade AstLinux Firmware (Remove | + | First, upgrade AstLinux Firmware (Replace |
upgrade-run-image check http:// | upgrade-run-image check http:// | ||
Line 63: | Line 73: | ||
reboot | reboot | ||
+ | \\ | ||
+ | ---- | ||
+ | \\ | ||
+ | In case something went wrong, you can find help **[[userdoc: |