Differences

This shows you the differences between two versions of the page.

--- userdoc:upgrade-0.6 [2010/01/22 04:16]
tom Added 'Possible Issues' including NIC order change
+++ userdoc:upgrade-0.6 [2011/11/26 17:37] (current)
abelbeck
@@ Line 15: / Line 15: @@
   - https://pbx/admin/system.php
   - The default repository is http://mirror.astlinux.org/firmware
+  - If you want to test Asterisk 1.8 you need to change the "Repository URL" in the Prefs Tab to\\ http://mirror.astlinux.org/ast18-firmware
   - Select "check for new", check the confirm checkbox, then click the firmware button.
@@ Line 35: / Line 36: @@
   - ''%%upgrade-run-image upgrade http://mirror.astlinux.org/firmware%%''
   - Reboot when prompted
+//or the URL from above for Asterisk 1.8.//
 If you used the firewall in the web GUI in 0.6, you will need to upgrade Arno's firewall:
@@ Line 55: / Line 58: @@
 **NOTE:** AstLinux supports retaining multiple versions in the %%'%%''os''%%'%% directory.  To determine which revision is booted, a %%'%%''ver''%%'%% file is used.  This ''ver'' file should contain a single line that lists the version to boot (for example: astlinux-0.6.1)  If no ''ver'' file is present, the boot loader will load the 'highest revision', determined alphabetically (so 0.6-2011 would be newer than 0.6.2).  So be careful if upgrading from an SVN version!
 ===== Possible Issues =====
-If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade.
+=== NICs ===
+If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]].
+=== Asterisk CLI commands ===
+You may also need to change the Active Channels, Voicemail and Reload Asterisk Commands, in the Prefs tab:
+  * Active Channels Command: ''core show channels''
+  * Voicemail Users Command: ''voicemail show users''
+  * Reload Voicemail Command: ''module reload app_voicemail.so''
+  * Reload Asterisk Command: ''module reload''