userdoc:upgrade-0.6

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
userdoc:upgrade-0.6 [2011/03/17 10:43]
droemel
userdoc:upgrade-0.6 [2011/11/26 17:37]
abelbeck
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
-====== Upgrade from 0.6.x (or later) ======+====== Upgrade from 0.6.x ======
  
 Please read [[http://astlinux.svn.sourceforge.net/viewvc/astlinux/branches/0.7/UPGRADE.txt|UPGRADE.txt]] and [[changes-0.7]] before you start.\\ If you are using mISDN with PCI cards please also read **[[misdn|this]]**.  Please read [[http://astlinux.svn.sourceforge.net/viewvc/astlinux/branches/0.7/UPGRADE.txt|UPGRADE.txt]] and [[changes-0.7]] before you start.\\ If you are using mISDN with PCI cards please also read **[[misdn|this]]**. 
Line 63: Line 63:
 If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]]. If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]].
  
-=== Asterisk commands ===+=== Asterisk CLI commands ===
 You may also need to change the Active Channels, Voicemail and Reload Asterisk Commands, in the Prefs tab: You may also need to change the Active Channels, Voicemail and Reload Asterisk Commands, in the Prefs tab:
  
  • userdoc/upgrade-0.6.txt
  • Last modified: 2011/11/26 17:37
  • by abelbeck