userdoc:upgrade-0.6

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
userdoc:upgrade-0.6 [2011/03/17 10:41]
droemel 		userdoc:upgrade-0.6 [2011/03/17 10:44]
droemel
Line 63: Line 63:
 If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]]. If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]].
  
-=== Asterisk commands === +=== Asterisk CLI commands === 
-You may also need to change the Active Channels, Voicemail Users and Reload Asterisk Commands, in the Prefs tab:+You may also need to change the Active Channels, Voicemail and Reload Asterisk Commands, in the Prefs tab:
  
   * Active Channels Command: ''core show channels''   * Active Channels Command: ''core show channels''
   * Voicemail Users Command: ''voicemail show users''   * Voicemail Users Command: ''voicemail show users''
 +  * Reload Voicemail Command: ''module reload app_voicemail.so''
   * Reload Asterisk Command: ''module reload''   * Reload Asterisk Command: ''module reload''
  • userdoc/upgrade-0.6.txt
  • Last modified: 2011/11/26 17:37
  • by abelbeck