userdoc:upgrade-0.6

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
userdoc:upgrade-0.6 [2011/03/17 10:38]
droemel 		userdoc:upgrade-0.6 [2011/03/17 10:39]
droemel
Line 62: Line 62:
 If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]]. If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]].
  
-You'll also need to change the Active Channels and Voicemail Users Commands, under Management Preferences tab, as follows:+You may also need to change the Active Channels, Voicemail Users and Reload Asterisk Commands, in the Prefs under Management Preferences tab:
  
   * Active Channels Command: ''core show channels''   * Active Channels Command: ''core show channels''
   * Voicemail Users Command: ''voicemail show users''   * Voicemail Users Command: ''voicemail show users''
   * Reload Asterisk Command: ''module reload''   * Reload Asterisk Command: ''module reload''
  • userdoc/upgrade-0.6.txt
  • Last modified: 2011/11/26 17:37
  • by abelbeck