This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
userdoc:upgrade-0.6 [2011/03/10 11:44]
droemel |
userdoc:upgrade-0.6 [2011/03/17 10:38]
droemel |
| |
| **NOTE:** AstLinux supports retaining multiple versions in the %%'%%''os''%%'%% directory. To determine which revision is booted, a %%'%%''ver''%%'%% file is used. This ''ver'' file should contain a single line that lists the version to boot (for example: astlinux-0.6.1) If no ''ver'' file is present, the boot loader will load the 'highest revision', determined alphabetically (so 0.6-2011 would be newer than 0.6.2). So be careful if upgrading from an SVN version! | **NOTE:** AstLinux supports retaining multiple versions in the %%'%%''os''%%'%% directory. To determine which revision is booted, a %%'%%''ver''%%'%% file is used. This ''ver'' file should contain a single line that lists the version to boot (for example: astlinux-0.6.1) If no ''ver'' file is present, the boot loader will load the 'highest revision', determined alphabetically (so 0.6-2011 would be newer than 0.6.2). So be careful if upgrading from an SVN version! |
| |
| ===== Possible Issues ===== | ===== Possible Issues ===== |
| |
| If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]]. | If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]]. |
| | |
| | You'll also need to change the Active Channels and Voicemail Users Commands, under Management Preferences tab, as follows: |
| | |
| | * Active Channels Command: ''core show channels'' |
| | * Voicemail Users Command: ''voicemail show users'' |
| | * Reload Asterisk Command: ''module reload'' |