Differences

This shows you the differences between two versions of the page.

--- userdoc:upgrade-0.6 [2010/01/22 04:16]
tom Added 'Possible Issues' including NIC order change
+++ userdoc:upgrade-0.6 [2011/03/10 11:44]
droemel
@@ Line 1: / Line 1: @@
 ~~NOTOC~~
-====== Upgrade from 0.6.x ======
+====== Upgrade from 0.6.x (or later) ======
 Please read [[http://astlinux.svn.sourceforge.net/viewvc/astlinux/branches/0.7/UPGRADE.txt|UPGRADE.txt]] and [[changes-0.7]] before you start.\\ If you are using mISDN with PCI cards please also read **[[misdn|this]]**.
@@ Line 15: / Line 15: @@
   - https://pbx/admin/system.php
   - The default repository is http://mirror.astlinux.org/firmware
+  - If you want to test Asterisk 1.8 you need to change the "Repository URL" in the Prefs Tab to\\ http://mirror.astlinux.org/ast18-firmware
   - Select "check for new", check the confirm checkbox, then click the firmware button.
@@ Line 35: / Line 36: @@
   - ''%%upgrade-run-image upgrade http://mirror.astlinux.org/firmware%%''
   - Reboot when prompted
+//or the URL from above for Asterisk 1.8.//
 If you used the firewall in the web GUI in 0.6, you will need to upgrade Arno's firewall:
@@ Line 58: / Line 61: @@
 ===== Possible Issues =====
-If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade.
+If your existing 0.6 installation has NICs of more than one type (different chipsets/drivers), there is the possibility that the numbering of these NICs under 0.6 (eg ''eth0'', ''eth1'', etc) will change once upgraded to 0.7. Please bear this in mind, especially if attempting a remote upgrade. For an explanation, see [[userdoc:tt_change_net_hardware|Changing Network Hardware]].