Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
userdoc:upgrade-0.6 [2010/01/05 17:27] droemel |
userdoc:upgrade-0.6 [2011/03/17 10:44] droemel |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
- | ====== Upgrade from 0.6.x ====== | + | ====== Upgrade from 0.6.x (or later) |
- | Please read [[http:// | + | Please read [[http:// |
===== Automated Process ===== | ===== Automated Process ===== | ||
Line 12: | Line 12: | ||
=== Using the web interface: === | === Using the web interface: === | ||
- | - browse | + | - Browse |
- https:// | - https:// | ||
- The default repository is http:// | - The default repository is http:// | ||
+ | - If you want to test Asterisk 1.8 you need to change the " | ||
- Select "check for new", check the confirm checkbox, then click the firmware button. | - Select "check for new", check the confirm checkbox, then click the firmware button. | ||
Line 20: | Line 21: | ||
Next, change the dropdown to " | Next, change the dropdown to " | ||
+ | |||
+ | If you used the firewall in the web GUI in 0.6, you will need to upgrade Arno's firewall: | ||
+ | |||
+ | - Network tab > Firewall sub-tab > Save Settings | ||
+ | - Firewall sub-tab > Restart Firewall | ||
+ | - A message is displayed saying that the firewall supporting files need upgrading | ||
+ | - Firewall sub-tab > Upgrade/ | ||
=== Command line interface: === | === Command line interface: === | ||
Line 25: | Line 33: | ||
On the command line, the commands are similar: | On the command line, the commands are similar: | ||
- | - %%upgrade-run-image check http:// | + | - '' |
- | - %%upgrade-run-image upgrade http:// | + | - '' |
- | - reboot | + | - Reboot |
+ | |||
+ | //or the URL from above for Asterisk 1.8.// | ||
+ | |||
+ | If you used the firewall in the web GUI in 0.6, you will need to upgrade Arno's firewall: | ||
+ | |||
+ | - '' | ||
+ | - '' | ||
+ | - '' | ||
+ | - '' | ||
===== Manual Process ===== | ===== Manual Process ===== | ||
Line 40: | Line 57: | ||
- '' | - '' | ||
- | **NOTE:** AstLinux supports retaining multiple versions in the ' | + | **NOTE:** AstLinux supports retaining multiple versions in the %%' |
+ | ===== Possible Issues ===== | ||
+ | |||
+ | === NICs === | ||
+ | If your existing 0.6 installation has NICs of more than one type (different chipsets/ | ||
+ | |||
+ | === Asterisk CLI commands === | ||
+ | You may also need to change the Active Channels, Voicemail and Reload Asterisk Commands, in the Prefs tab: | ||
+ | * Active Channels Command: '' | ||
+ | * Voicemail Users Command: '' | ||
+ | * Reload Voicemail Command: '' | ||
+ | * Reload Asterisk Command: '' |