userdoc:tt_wan_failover

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
userdoc:tt_wan_failover [2021/01/19 13:13]
mkeuter [AVM FRITZ!Box 6820v3 LTE as LTE Router] 		userdoc:tt_wan_failover [2021/01/19 13:13]
mkeuter [AVM FRITZ!Box 6820v3 LTE as LTE Router]
Line 349: Line 349:
   * on the homepage click at the 3 dots in the upper right corner and enable "Advanced View"   * on the homepage click at the 3 dots in the upper right corner and enable "Advanced View"
   * under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the "IPv4 Address" (to e.g. ''192.168.5.1''), cause every FRITZ!Box by default uses ''192.168.178.1'' and that can lead to problems when using VPNs or other FRITZ!Boxes.   * under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the "IPv4 Address" (to e.g. ''192.168.5.1''), cause every FRITZ!Box by default uses ''192.168.178.1'' and that can lead to problems when using VPNs or other FRITZ!Boxes.
-  * setup your AstLinux Failover interface with a static address from the same network (best below .20 because of DHCP) e.g. ''192.168.5.11'' and reboot AstLinux.+  * setup your AstLinux Failover interface with a static address from the same network (best below ''.20'' because of DHCP) e.g. ''192.168.5.11'' and reboot AstLinux.
   * under "Internet/Permit Access" click "Add Device for Sharing" and enable the "Exposed Host" function for your AstLinux Failover interface.   * under "Internet/Permit Access" click "Add Device for Sharing" and enable the "Exposed Host" function for your AstLinux Failover interface.
  • userdoc/tt_wan_failover.txt
  • Last modified: 2021/01/19 13:15
  • by mkeuter