Differences

This shows you the differences between two versions of the page.

--- userdoc:tt_wan_failover [2021/01/19 12:59]
mkeuter [Example: WiFi Bridge Failover]
+++ userdoc:tt_wan_failover [2021/01/19 13:15]
mkeuter [AVM FRITZ!Box 6820v3 LTE as LTE Router]
@@ Line 343: / Line 343: @@
 ===== AVM FRITZ!Box 6820v3 LTE as LTE Router =====
-  * on the homepage click at the 3 dots in the upper right corner and enable "Advanced View"
+The AVM FRITZ!Box series is very common in Germany and parts of Europe. The 6820 LTE should work across Europe.
-  * under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the IPv4 Address (e.g. 192.168.5.1), cause every FRITZ!Box by default uses 192.168.178.1 and that can lead to problems when using VPNs or other FRITZ!Boxes.
-  * setup your AstLinux Failover interface with a static address from the same network (best below .20) e.g. 192.168.5.11 and reboot AstLinux.
+[[https://en.avm.de/products/fritzbox/fritzbox-6820-lte/|Product Info]]
+  * on the FRITZ!Box overview page click on the 3 dots in the upper right corner and enable "Advanced View"
+  * under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the "IPv4 Address" (to e.g. ''192.168.5.1''), cause every FRITZ!Box by default uses ''192.168.178.1'' and that can lead to problems when using VPNs or other FRITZ!Boxes.
+  * setup your AstLinux Failover interface with a static address from the same network (best below ''.20'' because of DHCP) e.g. ''192.168.5.11'' and reboot AstLinux.
   * under "Internet/Permit Access" click "Add Device for Sharing" and enable the "Exposed Host" function for your AstLinux Failover interface.