userdoc:tt_wan_failover

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
userdoc:tt_wan_failover [2019/10/13 21:03]
abelbeck [Action Exit Script (optional)] 		userdoc:tt_wan_failover [2021/01/19 12:59]
mkeuter [Example: WiFi Bridge Failover]
Line 97: Line 97:
   exit 0   exit 0
  
-===== Action Exit Script (optional) =====+\\ 
 +===== Exit Action Script (optional) =====
  
 !!Note: AstLinux 1.3.7 or later is required!! !!Note: AstLinux 1.3.7 or later is required!!
Line 339: Line 340:
     ... do stuff ...     ... do stuff ...
   fi   fi
 +  
 +===== AVM FRITZ!Box 6820v3 LTE as LTE Router =====
 +
 +  * on the homepage click at the 3 dots in the upper right corner and enable "Advanced View"
 +  * under "Home Network/Network/Network Settings/IP Addresses" click on "IPv4 Addresses" and change the IPv4 Address (e.g. 192.168.5.1), cause every FRITZ!Box by default uses 192.168.178.1 and that can lead to problems when using VPNs or other FRITZ!Boxes.
 +  * setup your AstLinux Failover interface with a static address from the same network (best below .20) e.g. 192.168.5.11 and reboot AstLinux.
 +  * under "Internet/Permit Access" click "Add Device for Sharing" and enable the "Exposed Host" function for your AstLinux Failover interface.
  • userdoc/tt_wan_failover.txt
  • Last modified: 2021/01/19 13:15
  • by mkeuter