Differences

This shows you the differences between two versions of the page.

--- userdoc:tt_virtualbox [2012/01/27 10:22]
abelbeck
+++ userdoc:tt_virtualbox [2016/02/05 09:03] (current)
droemel
@@ Line 1: / Line 1: @@
 ====== Convert AstLinux install files to VirtualBox ======
+!!Obsolete info with AstLinux 1.2.5 and later.!!  Use the ISO Installer Image.
-You can convert an astlinux-XX.img file to a VirtualBox .vdi and have a bootable system with a few simple steps.
+\\
+You can convert an astlinux-XX.img file to a [[https://www.virtualbox.org/wiki/Downloads|VirtualBox]] .vdi file and have a bootable system with a few simple steps.
   - Download an AstLinux 'geni586' .img.gz file
   - Decompress the image using gunzip, yielding a .img file
-  - Use the VBoxManage utility to convert the image to a virtual disk
+  - Use the VBoxManage (CLI) utility ([[https://www.virtualbox.org/wiki/Downloads|VirtualBox]]) to convert the image to a virtual disk
-  VBoxManage convertfromraw -format VDI astlinux-1.0.1-asterisk-1.8.8.1.img astlinux-1.0.1.vdi
+Example:
+  gunzip astlinux-1.2.3-asterisk-11.18.0.img.gz
+  VBoxManage convertfromraw -format VDI astlinux-1.2.3-asterisk-11.18.0.img astlinux-1.2.3.vdi
 //The formats VDI, VMDK and VHD are supported.//
-Then you can then resize the image to let's say 2 GB:
+Here is the complete manual of the [[https://www.virtualbox.org/manual/ch08.html#idp46854861724896|VBoxManage convertfromraw]] command.
-  VBoxManage modifyhd --resize <new size in MB> <path to image> e.g.
+\\
+Then you can then resize the image...
+Usage:
+  VBoxManage modifyhd --resize <new size in MB> <path to image>
+Example (let's say 2 GB):
-  VBoxManage modifyhd --resize 2048 /Users/astlinux/astlinux-1.0.1.vdi
+  VBoxManage modifyhd --resize 2048 astlinux-1.2.3.vdi
-Then simply create a new virtual machine using this file as the disk and start the normal **[[userdoc:new-install|setup]]**.
+Then simply create a new VirtualBox virtual machine using this .vdi file as the disk (I used a network bridge (en0) and the PCnet-Fast III adapter for the 'geni586' image on a Mac).
+Start the AstLinux Virtual Machine...
+Finally, configure using the normal **[[userdoc:new-install|setup]]**.
 /* Be sure to use it as IDE harddisk in VirtualBox (default is SATA). You also need to create a secondary IDE harddisk for UnionFS.
@@ Line 26: / Line 45: @@
 In my case it was ''/dev/hdb'', you can verify this with '''fdisk -l'''. \\ */
-I used a network bridge (en0) and the PCnet-Fast III adapter for the 'geni586' image (on a Mac).