This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
userdoc:tt_ups_monitoring [2014/01/11 23:09]
abelbeck [CLI Custom Configuration] |
userdoc:tt_ups_monitoring [2016/01/04 12:29]
droemel [General Configuration] |
| {{:userdoc:ups-default-config.jpg?nolink|UPS Default Configuration}} | {{:userdoc:ups-default-config.jpg?nolink|UPS Default Configuration}} |
| |
| !!Note ->!! By default the "UPS Password" is: ''astlinux'' | !!Note ->!! By default the "UPS Password" is: ''astlinux'', the firewall port, if needed, is 3493/TCP. |
| |
| \\ | \\ |
| |
| Finally, the "Kill Power on the UPS after a Powerfail Shutdown" only applies if a "UPS Driver" is defined. When enabled this option will instruct the UPS to cut power if both on battery and a shutdown is in progress. Power will be cut approximately 60 seconds after a shutdown. The idea is when line power is restored the battery will not be totally depleted and the UPS connected device will be power cycled off/on. | Finally, the "Kill Power on the UPS after a Powerfail Shutdown" only applies if a "UPS Driver" is defined. When enabled this option will instruct the UPS to cut power if both on battery and a shutdown is in progress. Power will be cut approximately 60 seconds after a shutdown. The idea is when line power is restored the battery will not be totally depleted and the UPS connected device will be power cycled off/on. |
| |
| ==== Display UPS Status ==== | ==== Display UPS Status ==== |
| |