Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:tt_runnix [2010/12/19 07:42] droemel |
userdoc:tt_runnix [2011/11/29 18:05] abelbeck |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== RUNNIX ====== | ====== RUNNIX ====== | ||
- | The AstLinux **[[system-config# | + | It is very important to understand that while AstLinux 0.7.x uses the runnix-0.3 (or runnix-0.2.1) bootloader, AstLinux 1.0.x requires the runnix-0.4 bootloader. This change is required since the Linux Kernel differences require different squashfs image formats. |
+ | |||
+ | The AstLinux **[[system-config# | ||
If you currently have problems booting with a SATA drive, or just want the latest features, after you upgrade to 0.7.5, and with internet connectivity, | If you currently have problems booting with a SATA drive, or just want the latest features, after you upgrade to 0.7.5, and with internet connectivity, | ||
Line 10: | Line 12: | ||
After a reboot, you will see the text below, you have 5 seconds to type a character, otherwise the normal boot will automatically proceed. | After a reboot, you will see the text below, you have 5 seconds to type a character, otherwise the normal boot will automatically proceed. | ||
- | < | + | < |
+ | ################################## | ||
# RUNNIX - AstLinux bootloader | # RUNNIX - AstLinux bootloader | ||
################################## | ################################## | ||
Line 27: | Line 30: | ||
* You can hit ''' | * You can hit ''' | ||
- | * You __cannot stop__ a normal ''' | + | * You __cannot stop__ a normal ''' |
* You can use disk repair commands like ''' | * You can use disk repair commands like ''' | ||
- | * For __non-serial__ consoles (i586/VIA) you can use an alternate **[[userdoc: | + | * For __non-serial__ consoles (i586/VIA) you can now use an alternate **[[userdoc: |
+ | * For ssh to work, you may need to edit the network settings in '''/ | ||
+ | * By default (if not defined) the network variables are: | ||
+ | * NIC = eth0 | ||
+ | * IP = DHCP | ||
+ | * ssh port = 2222. | ||
+ | * To reboot from the console you need to type ''' | ||
+ | * You'll find the stuff that's normally in ''/ | ||
\\ | \\ | ||