userdoc:tt_ipv6_ula_nptv6_config

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
userdoc:tt_ipv6_ula_nptv6_config [2017/06/04 12:30]
abelbeck [IPv6 ULA / NPTv6 Configuration]
userdoc:tt_ipv6_ula_nptv6_config [2017/06/04 12:54]
abelbeck [IPv6 ULA / NPTv6 Configuration]
Line 6: Line 6:
 **[[userdoc:tt-dhcpv6-prefix-delegation|DHCPv6 with Prefix Delegation]]** **[[userdoc:tt-dhcpv6-prefix-delegation|DHCPv6 with Prefix Delegation]]**
  
-Should everyone configure IPv6 with ULA / NPTv6 ?  Not everyone.  These are common situations when IPv6 with ULA / NPTv6 is useful, it it applies read no below;+Should everyone configure IPv6 with ULA / NPTv6 ?  Not everyone.  For some, simply selecting "Assign GUA Prefix" for your LAN internal interface is all that is needed to provide global IPv6 connectivity for your devices. 
 + 
 +Listed are common situations when IPv6 with ULA / NPTv6 is useful, if any applies continue reading below
 + 
 +  * OpenVPN Server - you want to route IPv6 in the tunnel 
 +  * Downstream IPv6 subnets that are statically defined 
 +  * Transition from IPv4 to IPv6 but don't want GUA's everywhere 
 +  * Define static firewall rules based on ULA'
 +  * Want to design an IPv6 network containing minimal ISP //owned// IPv6 prefixes 
  
-  * OpenVPN - you want to route IPv6 in the tunnel 
  
 !!Note: AstLinux 1.3.0 or later is required!! !!Note: AstLinux 1.3.0 or later is required!!
  • userdoc/tt_ipv6_ula_nptv6_config.txt
  • Last modified: 2017/06/04 13:27
  • by abelbeck