This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
userdoc:tt_edgerouter-x [2022/08/29 07:04] mkeuter |
userdoc:tt_edgerouter-x [2022/08/29 07:12] mkeuter [Alternatives to the EdgeRouter X] |
With the "System Load Linux to SDRAM via TFTP" chosen, you need to specify two IP addresses and the name of the TFTP filename ''openwrt.bin'', as show above. | With the "System Load Linux to SDRAM via TFTP" chosen, you need to specify two IP addresses and the name of the TFTP filename ''openwrt.bin'', as show above. |
| |
!!Note:!! Some OpenWRT devices work exclusively with ''192.168.1.1'' + ''192.168.1.2'' as the device + server IP addresses! ((use e.g.\\ ''ifconfig eth1:1 192.168.1.2 netmask 255.255.255.0 up''\\ to add a virtual address to the server)) | !!Note:!! Some OpenWRT devices work exclusively with ''192.168.1.1'' + ''192.168.1.2'' as the device + server IP addresses! ((use e.g.\\ ''ifconfig eth1:1 192.168.1.2 netmask 255.255.255.0 up''\\ to add an additional virtual address to the server)) |
| |
Type RETURN and the ER-X should reboot into the factory initramfs-kernel of OpenWrt. After the dmesg logs appear to stop, type RETURN again, you should see a login as shown below: | Type RETURN and the ER-X should reboot into the factory initramfs-kernel of OpenWrt. After the dmesg logs appear to stop, type RETURN again, you should see a login as shown below: |
{{:userdoc:edgerouter-x-firewall-wg-interface.png?nolink|Firewall WireGuard Interface}} | {{:userdoc:edgerouter-x-firewall-wg-interface.png?nolink|Firewall WireGuard Interface}} |
| |
| ===== Alternatives to the EdgeRouter X ===== |
| |
| The EdgeRouter-X is now hard to get or EOL. Kind of alternatives are the "travel router" devices from [[https://www.gl-inet.com/products/|GL.inet]] as they based on OpenWRT and already include WireGuard and OpenVPN. |
| |
| |
| \\ |
| \\ |
| ---- |