Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
userdoc:tt_distribute_events_xmpp_pubsub [2013/08/29 21:50] abelbeck [Configure Local Server1] |
userdoc:tt_distribute_events_xmpp_pubsub [2013/09/01 05:30] (current) droemel [Configure Remote Server2] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Distribute Asterisk Events using XMPP PubSub ====== | ====== Distribute Asterisk Events using XMPP PubSub ====== | ||
- | On occasion it is desirable to distribute device state and message waiting indication (MWI) events between Asterisk servers. | + | On occasion it is desirable to distribute device state (e.g. BLF) and message waiting indication (MWI) events between Asterisk servers. This can be accomplished by utilizing XMPP PubSub events and a common XMPP server. The Asterisk XMPP clients are configured via either '' |
!!Note: AstLinux 1.1.3 or later is required!! | !!Note: AstLinux 1.1.3 or later is required!! | ||
Line 7: | Line 7: | ||
===== Configure Local Server1 ===== | ===== Configure Local Server1 ===== | ||
- | **Snippet - '' | + | **Snippet - Asterisk |
[general] | [general] | ||
Line 50: | Line 50: | ||
**Snippet - '' | **Snippet - '' | ||
- | ; DEVICE_STATE hint example | + | |
+ | | ||
+ | exten => 24, | ||
===== Configure Remote Server2 ===== | ===== Configure Remote Server2 ===== | ||
- | **Snippet - '' | + | **Snippet - Asterisk |
[general] | [general] | ||
Line 78: | Line 79: | ||
**Snippet - '' | **Snippet - '' | ||
- | ; DEVICE_STATE hint example | + | |
+ | [blf_server1] | ||
+ | exten => 1024, | ||
+ | |||
+ | !!Note ->!! Only the **device state** (INUSE, NOT_INUSE, RINGING) of **" | ||
+ | |||
+ | Now you can simply create a BLF key on a phone on Server2 for " | ||
+ | |||
+ | The Message Waiting Indication (MWI) events are also distributed across servers. For the above example you just need to add this to a phone in your '' | ||
+ | |||
+ | mailbox=24 | ||
+ | |||
+ | as if it were a local mailbox. You will either need different mailbox numbers on each side or different voicemail contexts, if you want to use the MWI feature. You can check the MWI status in the Asterisk CLI with: | ||
+ | |||
+ | event dump cache MWI | ||