Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:tt_distribute_events_xmpp_pubsub [2013/08/29 21:57] abelbeck [Configure Local Server1] |
userdoc:tt_distribute_events_xmpp_pubsub [2013/09/01 05:07] droemel [Configure Remote Server2] |
||
---|---|---|---|
Line 7: | Line 7: | ||
===== Configure Local Server1 ===== | ===== Configure Local Server1 ===== | ||
- | **Snippet - '' | + | **Snippet - Asterisk |
[general] | [general] | ||
Line 50: | Line 50: | ||
**Snippet - '' | **Snippet - '' | ||
- | ; DEVICE_STATE hint example | + | |
+ | | ||
+ | exten => 24, | ||
===== Configure Remote Server2 ===== | ===== Configure Remote Server2 ===== | ||
- | **Snippet - '' | + | **Snippet - Asterisk |
[general] | [general] | ||
Line 78: | Line 79: | ||
**Snippet - '' | **Snippet - '' | ||
- | ; DEVICE_STATE hint example | + | |
+ | [blf_server1] | ||
+ | exten => 1024, | ||
+ | |||
+ | !!Note ->!! Only the **device state** (INUSE, NOT_INUSE, RINGING) of **" | ||
+ | |||
+ | Now you can simply create a BLF key on a phone on Server2 for " | ||
+ | |||
+ | The Message Waiting Indication (MWI) events are also distributed across servers. For the above example you just need to add this to a phone in your '' | ||
+ | |||
+ | mailbox=24 | ||
+ | |||
+ | as if it were a local mailbox. You will need different mailbox numbers on each side, if you want to use the MWI feature. You can check the MWI status in the Asterisk CLI with: | ||
+ | |||
+ | event dump cache MWI | ||