Differences

This shows you the differences between two versions of the page.

--- userdoc:tt_asterisk_snmp_monitoring [2013/05/08 15:10]
abelbeck [Asterisk SNMP Configuration]
+++ userdoc:tt_asterisk_snmp_monitoring [2016/06/28 18:48] (current)
abelbeck [System SNMP Configuration]
@@ Line 21: / Line 21: @@
   syslocation Omaha, NE
-  syscontact AstLinux - www.astlinux.org
+  syscontact AstLinux - www.astlinux-project.org
   agentaddress udp:127.0.0.1:161
@@ Line 30: / Line 30: @@
   sysObjectID .1.3.6.1.4.1.22736.1
-  mibs +ASTERISK-MIB
 Edit ''syslocation'' and ''syscontact'' for your location.
-\\
-Apply snmpd.conf changes, restart snmpd service using CLI:
+Apply ''snmpd.conf'' changes, restart snmpd service using CLI:
   service snmpd stop
   service snmpd init
+With the system ''snmpd.conf'' changes applied, you should see useful information with the following commands.
 Example snmp commands using CLI:
@@ Line 56: / Line 57: @@
 ===== Asterisk SNMP Configuration =====
-Enable SNMP in Asterisk using /etc/asterisk/res_snmp.conf
+Enable SNMP in Asterisk by editing ''/etc/asterisk/res_snmp.conf'' in the ''[general]'' section:
   ;
@@ Line 63: / Line 64: @@
   ;
   ; -- snip --
-  ; See https://wiki.asterisk.org/wiki/display/AST/Simple+Network+Management+Protocol+(SNMP)+Support
-  ; to get more information about
-  ; snmp support in Asterisk
   [general]
@@ Line 73: / Line 71: @@
   ; SNMP must be explicitly enabled to be active
   enabled = yes
-\\
+Apply the ''res_snmp.conf'' change in Asterisk, unload and load the ''res_snmp.so'' module, or restart the asterisk service.
+With both the system ''snmpd.conf'' and Asterisk ''res_snmp.conf'' changes applied, you should see useful information with the following commands.
 Example snmp commands using CLI: