Differences

This shows you the differences between two versions of the page.

--- userdoc:tt_asterisk_snmp_monitoring [2013/05/08 20:14] – [Asterisk SNMP Configuration] abelbeck
+++ userdoc:tt_asterisk_snmp_monitoring [2016/06/28 23:48] (current) – [System SNMP Configuration] abelbeck
@@ Line 21: / Line 21: @@
   syslocation Omaha, NE
-  syscontact AstLinux - www.astlinux.org
+  syscontact AstLinux - www.astlinux-project.org
   agentaddress udp:127.0.0.1:161
@@ Line 30: / Line 30: @@
   sysObjectID .1.3.6.1.4.1.22736.1
-  mibs +ASTERISK-MIB
 Edit ''syslocation'' and ''syscontact'' for your location.
-\\
-Apply snmpd.conf changes, restart snmpd service using CLI:
+Apply ''snmpd.conf'' changes, restart snmpd service using CLI:
   service snmpd stop
   service snmpd init
+With the system ''snmpd.conf'' changes applied, you should see useful information with the following commands.
 Example snmp commands using CLI:
@@ Line 70: / Line 71: @@
   ; SNMP must be explicitly enabled to be active
   enabled = yes
-\\
-Apply the res_snmp.conf change in Asterisk, unload and load the res_snmp.so module, or restart the asterisk service.
+Apply the ''res_snmp.conf'' change in Asterisk, unload and load the ''res_snmp.so'' module, or restart the asterisk service.
+With both the system ''snmpd.conf'' and Asterisk ''res_snmp.conf'' changes applied, you should see useful information with the following commands.
 Example snmp commands using CLI: