Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
userdoc:tt_asterisk_snmp_monitoring [2013/05/08 15:12] abelbeck [Asterisk SNMP Configuration] |
userdoc:tt_asterisk_snmp_monitoring [2013/05/08 15:18] abelbeck [System SNMP Configuration] |
||
|---|---|---|---|
| Line 33: | Line 33: | ||
| Edit '' | Edit '' | ||
| - | \\ | ||
| Apply snmpd.conf changes, restart snmpd service using CLI: | Apply snmpd.conf changes, restart snmpd service using CLI: | ||
| Line 39: | Line 38: | ||
| service snmpd stop | service snmpd stop | ||
| service snmpd init | service snmpd init | ||
| + | |||
| + | With the system snmpd.conf changes applied, you should see useful information with the following commands. | ||
| Example snmp commands using CLI: | Example snmp commands using CLI: | ||
| Line 70: | Line 71: | ||
| ; SNMP must be explicitly enabled to be active | ; SNMP must be explicitly enabled to be active | ||
| enabled = yes | enabled = yes | ||
| - | \\ | + | |
| + | Apply the res_snmp.conf change in Asterisk, unload and load the res_snmp.so module, or restart the asterisk service. | ||
| + | |||
| + | With both the system snmpd.conf and Asterisk res_snmp.conf changes applied, you should see useful information with the following commands. | ||
| Example snmp commands using CLI: | Example snmp commands using CLI: | ||