Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:tt_asterisk-gui [2010/07/23 18:36] abelbeck |
userdoc:tt_asterisk-gui [2015/05/16 11:06] abelbeck [Using the Asterisk GUI] |
||
---|---|---|---|
Line 5: | Line 5: | ||
The Asterisk GUI is an open source project created by [[http:// | The Asterisk GUI is an open source project created by [[http:// | ||
- | The username/ | + | !!No longer supported with AstLinux 1.2.3 and later!! |
+ | ===== Configuration Files ===== | ||
- | ''; | + | Two files are key to allowing the Asterisk GUI to operate, located at: |
- | [admin]\\ | + | * '' |
- | secret = astlinux\\ | + | * ''/ |
- | ;deny = 0.0.0.0/ | + | |
- | ;permit = 192.168.101.1/ | + | Additionally, |
- | read = system, | + | |
- | write = system, | + | cp / |
- | '' | + | |
+ | |||
+ | ===== Asterisk manager.conf ===== | ||
+ | |||
+ | The default '' | ||
+ | |||
+ | [general] | ||
+ | enabled = yes | ||
+ | webenabled = yes | ||
+ | |||
+ | port = 5038 | ||
+ | bindaddr = 0.0.0.0 | ||
+ | |||
+ | The username/ | ||
+ | |||
+ | | ||
+ | [admin] | ||
+ | secret = astlinux | ||
+ | ;deny = 0.0.0.0/ | ||
+ | ;permit = 192.168.101.1/ | ||
+ | read = system, | ||
+ | write = system, | ||
+ | |||
+ | Be sure to change the password and possibly also uncomment/ | ||
+ | |||
+ | ===== Asterisk http.conf ===== | ||
+ | |||
+ | The default '' | ||
+ | |||
+ | [general] | ||
+ | ; | ||
+ | enabled=yes | ||
+ | ; | ||
+ | bindaddr=0.0.0.0 | ||
+ | ; | ||
+ | ; Port to bind to for HTTP sessions (default is 8088) | ||
+ | ; | ||
+ | ; | ||
+ | ; | ||
+ | ; Prefix allows you to specify a prefix for all requests | ||
+ | ; to the server. | ||
+ | ; all requests must begin with /asterisk | ||
+ | ; | ||
+ | ; | ||
+ | ; | ||
+ | ; sessionlimit specifies the maximum number of httpsessions that will be | ||
+ | ; allowed to exist at any given time. (default: 100) | ||
+ | ; | ||
+ | ; | ||
+ | ; | ||
+ | ; Whether Asterisk should serve static content from http-static | ||
+ | ; Default is no. | ||
+ | ; | ||
+ | enablestatic=yes | ||
+ | ; | ||
+ | ; Redirect one URI to another. | ||
+ | ; default page. | ||
+ | ; | ||
+ | ; For example, if you are using the Asterisk-gui, | ||
+ | ; it is convenient to enable the following redirect: | ||
+ | ; | ||
+ | ;redirect = / / | ||
+ | ; | ||
+ | |||
+ | A new install '' | ||
+ | |||
+ | ===== Asterisk GUI - URL ===== | ||
+ | |||
+ | Restart asterisk for any of the above file changes to become active. | ||
+ | |||
+ | Access the Asterisk GUI using the following URL: | ||
+ | |||
+ | http:// | ||
+ | |||
+ | Username: admin\\ | ||
+ | Password: //secret// from '' | ||
- | Add this section if it does not already exist. Be sure to change the password and possibly also uncomment/ |