userdoc:tt-bridges

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
userdoc:tt-bridges [2012/10/21 08:38]
abelbeck 		userdoc:tt-bridges [2012/10/21 08:40]
abelbeck
Line 1: Line 1:
 ====== Network-Bridges (BRIDGE0) ====== ====== Network-Bridges (BRIDGE0) ======
  
-When you setup a software network bridge in AstLinux, you need to careful to not lock out your network connection:+When you setup a software network bridge in AstLinux, you need to be careful to not lock out your network connection:
  
 **Q:** When I enter ''BRIDGE0="eth0 eth3"'' in the user.conf and reboot, why is then ''eth0'' not reachable over the network ? **Q:** When I enter ''BRIDGE0="eth0 eth3"'' in the user.conf and reboot, why is then ''eth0'' not reachable over the network ?
Line 13: Line 13:
   INTIF="br0"   INTIF="br0"
      
-in your ''user.conf''. Then after a reboot the (new) bridge will appear in the menu in the Network tab, select ''br0'' as normal and then remove the ''EXTIF'' (or ''INTIF'')entry in ''user.conf''.+in your ''user.conf''. Then after a reboot the (new) bridge will appear in the menu in the Network tab, select ''br0'' as normal and then remove the ''EXTIF'' (or ''INTIF'') entry in ''user.conf''.
  
 I know, a little confusing, but it's the only way since we have nice little drop-down menus of the "current" active interfaces. I know, a little confusing, but it's the only way since we have nice little drop-down menus of the "current" active interfaces.
  • userdoc/tt-bridges.txt
  • Last modified: 2023/07/27 11:33
  • by mkeuter