Differences

This shows you the differences between two versions of the page.

--- userdoc:new-install [2016/12/20 11:25]
droemel [New Installation]
+++ userdoc:new-install [2020/04/25 15:17]
abelbeck [Persistent Storage Options (GUI)]
@@ Line 8: / Line 8: @@
 **Typical New Installation:**
-  - Download the appropriate astlinux-xxx-board.iso image from the [[http://www.astlinux-project.org|AstLinux website]]. ((Various ISO images are available, built for specific [[devdoc:boardtypes|hardware]]. If you are unsure which to download, for 32-bit use the astlinux-xxx-geni586.iso image, for 64-bit use the astlinux-xxx-genx86_64.iso image.))
+  - Download the appropriate astlinux-xxx-board.iso image from the [[http://www.astlinux-project.org|AstLinux website]]. ((Various ISO images are available, built for specific [[devdoc:boardtypes|hardware]]. If you are unsure which to download, for 32-bit use the astlinux-xxx-geni586.iso image, for 64-bit use the astlinux-xxx-genx86_64.iso image.)) \\ Links to ISO installers for older hardware can be found [[userdoc:legacy-installer-iso|here]].
   - Transfer the ISO image to a USB flash drive:
     * On Linux or *BSD use ''dd'' to transfer the image, where sdX is your USB flash drive\\ ''$ dd if=astlinux-xxx-board.iso of=/dev/sdX''
@@ Line 44: / Line 44: @@
 Now you will see the following screen:
-{{userdoc:astlinux-setup-screen1.jpg?nolink|Setup1}}
+{{userdoc:astlinux-setup-screen1b.jpg?nolink|Setup1}}
 Here you can choose how you want to configure your persistent storage. The drop-down box shows the proposed installation device.  Read the instructions carefully and follow what it says.