Differences

This shows you the differences between two versions of the page.

--- userdoc:new-install [2020/04/25 15:26]
abelbeck [Persistent Storage Options (CLI)]
+++ userdoc:new-install [2020/04/26 07:41]
mkeuter [Persistent Storage Options (GUI)]
@@ Line 1: / Line 1: @@
 ====== New Installation ======
-Starting with !!AstLinux 1.2.5!! installation images are now contained within an ISO Installer Image (astlinux-xxx-board.iso) for each board type.  The ISO image can be used in several ways:
+Starting with !!AstLinux 1.2.5!! installation images are now contained within an ISO Installer Image (astlinux-xxx-board.iso) for each board type. \\
+Since !!AstLinux 1.3.10!! only 64-bit installations are supported.\\
+The ISO image can be used in several ways:
   * Write the ISO Installer image to a USB flash drive (''dd'' image mode), then boot using the USB drive and install to an internal disk.
   * Boot the ISO Installer image (ISO CDROM) within a Virtual Machine and install to a virtual disk.
@@ Line 28: / Line 30: @@
   * Configuration data (/mnt/kd/), such as the Asterisk configuration files, system settings and voicemail messages.
-Using a single partition combining Unionfs data and /mnt/kd/ data is the default for new installations. Optionally, you may specify in the installation setup to create separate Unionfs and /mnt/kd/ partitions, resulting in two partitions for persistent storage.
+/*Using a single partition combining Unionfs data and /mnt/kd/ data is the default for new installations. Optionally, you may specify in the installation setup to create separate Unionfs and /mnt/kd/ partitions, resulting in two partitions for persistent storage.*/
 Using a computer on the same network, open your favorite web browser and type the following...