Differences

This shows you the differences between two versions of the page.

--- userdoc:new-install [2020/04/25 15:17]
abelbeck [Persistent Storage Options (GUI)]
+++ userdoc:new-install [2020/04/26 07:13]
mkeuter [New Installation]
@@ Line 1: / Line 1: @@
 ====== New Installation ======
-Starting with !!AstLinux 1.2.5!! installation images are now contained within an ISO Installer Image (astlinux-xxx-board.iso) for each board type.  The ISO image can be used in several ways:
+Starting with !!AstLinux 1.2.5!! installation images are now contained within an ISO Installer Image (astlinux-xxx-board.iso) for each board type. \\
+Since !!AstLinux 1.3.10!! only 64-bit installations are supported.\\
+The ISO image can be used in several ways:
   * Write the ISO Installer image to a USB flash drive (''dd'' image mode), then boot using the USB drive and install to an internal disk.
   * Boot the ISO Installer image (ISO CDROM) within a Virtual Machine and install to a virtual disk.
@@ Line 46: / Line 48: @@
 {{userdoc:astlinux-setup-screen1b.jpg?nolink|Setup1}}
-Here you can choose how you want to configure your persistent storage. The drop-down box shows the proposed installation device.  Read the instructions carefully and follow what it says.
+Here you can choose how you want to format your persistent storage. The drop-down box shows the proposed installation device.  Read the instructions carefully and follow what it says.
 Then click **Continue**, the screen below will be displayed.
@@ Line 85: / Line 87: @@
   ok-format /dev/sda
-  $ initial-setup format combined /dev/sda  (or for a separate partition: format separate /dev/sda 256)
+  $ initial-setup format separate /dev/sda 256
   $ reboot