Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:new-install [2016/12/20 11:21] droemel |
userdoc:new-install [2020/04/26 07:13] mkeuter [New Installation] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== New Installation ====== | ====== New Installation ====== | ||
- | Starting with !!AstLinux 1.2.5!! installation images are now contained within an ISO Installer Image (astlinux-xxx-board.iso) for each board type. The ISO image can be used in several ways: | + | Starting with !!AstLinux 1.2.5!! installation images are now contained within an ISO Installer Image (astlinux-xxx-board.iso) for each board type. \\ |
+ | Since !!AstLinux 1.3.10!! only 64-bit installations are supported.\\ | ||
+ | The ISO image can be used in several ways: | ||
* Write the ISO Installer image to a USB flash drive ('' | * Write the ISO Installer image to a USB flash drive ('' | ||
* Boot the ISO Installer image (ISO CDROM) within a Virtual Machine and install to a virtual disk. | * Boot the ISO Installer image (ISO CDROM) within a Virtual Machine and install to a virtual disk. | ||
Line 8: | Line 10: | ||
**Typical New Installation: | **Typical New Installation: | ||
- | - Download the appropriate astlinux-xxx-board.iso image from the [[https:// | + | - Download the appropriate astlinux-xxx-board.iso image from the [[http:// |
- Transfer the ISO image to a USB flash drive: | - Transfer the ISO image to a USB flash drive: | ||
* On Linux or *BSD use '' | * On Linux or *BSD use '' | ||
Line 44: | Line 46: | ||
Now you will see the following screen: | Now you will see the following screen: | ||
- | {{userdoc: | + | {{userdoc: |
- | Here you can choose how you want to configure | + | Here you can choose how you want to format |
Then click **Continue**, | Then click **Continue**, | ||
Line 85: | Line 87: | ||
ok-format /dev/sda | ok-format /dev/sda | ||
| | ||
- | $ initial-setup | + | $ initial-setup format separate /dev/sda 256 |
| | ||
$ reboot | $ reboot |