Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:hosted_guest_vm_netcup [2019/10/05 08:32] mkeuter |
userdoc:hosted_guest_vm_netcup [2020/10/01 10:07] mkeuter |
||
---|---|---|---|
Line 5: | Line 5: | ||
**VM Host Specifications: | **VM Host Specifications: | ||
- | !!Note:!! netcup has its datacenter | + | !!Note:!! netcup has its Data Centre |
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 21: | Line 21: | ||
**Configuration: | **Configuration: | ||
- | After you created an account, netcup might verify your account via telephone. After that you'll get your creditentials | + | After you created an account, netcup might verify your account via telephone. After that you'll get your credentials |
In my case a Debian installation was pre-installed. | In my case a Debian installation was pre-installed. | ||
Line 36: | Line 36: | ||
{{: | {{: | ||
- | Select it activate DVD boot mode and enter your Servercontrolpanel password. Then go to '' | + | Select it, activate DVD boot mode and enter your Servercontrolpanel password. Then go to '' |
{{: | {{: | ||
- | Delete the pre-installed | + | Delete the pre-installed |
Now you can start your vServer and start with your normal AstLinux ISO installation: | Now you can start your vServer and start with your normal AstLinux ISO installation: | ||
Line 47: | Line 47: | ||
When finished select '' | When finished select '' | ||
+ | It is useful to enable the QEMU Guest Agent in your '' | ||
!!Tip ->!! Note the "IPv4 Address:" | !!Tip ->!! Note the "IPv4 Address:" | ||
Line 52: | Line 53: | ||
!!Warning ->!! It is important to enable the Firewall as soon as possible. Create rules with limited access for TCP ports 22,80,443 (SSH/ | !!Warning ->!! It is important to enable the Firewall as soon as possible. Create rules with limited access for TCP ports 22,80,443 (SSH/ | ||
- | !!Tip ->!! If you have trouble getting an IP-address via DHCP, do not fiddle with AstLinux, but instead contact the netcup support via their Customer Control Panel. In my case there was a general networking issue with my account, which was fixed within a day. | + | !!Tip ->!! If you have trouble getting an IP-address via DHCP, do not fiddle with AstLinux, but instead contact the netcup support via the contact form in their '' |