Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:hosted_guest_vm_netcup [2019/10/05 08:00] mkeuter |
userdoc:hosted_guest_vm_netcup [2020/10/01 10:07] mkeuter |
||
---|---|---|---|
Line 5: | Line 5: | ||
**VM Host Specifications: | **VM Host Specifications: | ||
- | !!Note:!! netcup has its datacenter | + | !!Note:!! netcup has its Data Centre |
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 21: | Line 21: | ||
**Configuration: | **Configuration: | ||
- | After you created an account, netcup might verify your account via telephone. After that you'll get your creditentials | + | After you created an account, netcup might verify your account via telephone. After that you'll get your credentials |
In my case a Debian installation was pre-installed. | In my case a Debian installation was pre-installed. | ||
- | No go to Media/DVD Drive: | + | Now go to Media/DVD Drive: |
{{: | {{: | ||
- | At the bottom of this page you'll find FTP credentials to upload your AstLinux ISO image into the '' | + | At the bottom of this page you'll find FTP credentials to upload your AstLinux ISO image via FTP into the '' |
{{: | {{: | ||
Line 36: | Line 36: | ||
{{: | {{: | ||
- | Select it activate DVD boot mode and enter your Servercontrolpanel password. | + | Select it, activate DVD boot mode and enter your Servercontrolpanel password. |
{{: | {{: | ||
- | Now delete | + | Delete |
- | then you can start your vServer and start with your normal AstLinux installation. After the AstLinux installation shutdown AstLinux in the ISO installer. Then go to '' | + | Now you can start your vServer and start with your normal AstLinux |
- | If you have trouble getting an IP-address via DHCP do not fiddle with AstLinux, but instead contact the netcup support via their Customer Control Panel. | + | Select the '' |
+ | |||
+ | When finished select '' | ||
+ | It is useful to enable the QEMU Guest Agent in your '' | ||
+ | |||
+ | !!Tip ->!! Note the "IPv4 Address:" | ||
+ | |||
+ | !!Warning ->!! It is important to enable the Firewall as soon as possible. Create rules with limited access for TCP ports 22,80,443 (SSH/ | ||
+ | |||
+ | !!Tip -> |