Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:hosted_guest_vm_netcup [2019/10/05 07:50] mkeuter |
userdoc:hosted_guest_vm_netcup [2019/10/05 08:35] mkeuter |
||
---|---|---|---|
Line 5: | Line 5: | ||
**VM Host Specifications: | **VM Host Specifications: | ||
- | !!Note:!! netcup has its datacenter | + | !!Note:!! netcup has its Data Centre |
**AstLinux Board Type:** | **AstLinux Board Type:** | ||
Line 24: | Line 24: | ||
In my case a Debian installation was pre-installed. | In my case a Debian installation was pre-installed. | ||
- | No go to Media/DVDs: | + | Now go to Media/DVD Drive: |
{{: | {{: | ||
+ | |||
+ | At the bottom of this page you'll find FTP credentials to upload your AstLinux ISO image via FTP into the '' | ||
{{: | {{: | ||
+ | |||
+ | After the upload the ISO will appear in '' | ||
{{: | {{: | ||
+ | |||
+ | Select it activate DVD boot mode and enter your Servercontrolpanel password. Then go to '' | ||
{{: | {{: | ||
+ | |||
+ | Delete the pre-installed harddisk and enter again your Servercontrolpanel password. | ||
+ | |||
+ | Now you can start your vServer and start with your normal AstLinux ISO installation: | ||
+ | |||
+ | Select the '' | ||
+ | |||
+ | When finished select '' | ||
+ | |||
+ | !!Tip ->!! Note the "IPv4 Address:" | ||
+ | |||
+ | !!Warning ->!! It is important to enable the Firewall as soon as possible. Create rules with limited access for TCP ports 22,80,443 (SSH/ | ||
+ | |||
+ | !!Tip ->!! If you have trouble getting an IP-address via DHCP, do not fiddle with AstLinux, but instead contact the netcup support via the contact form in their '' |