Differences

This shows you the differences between two versions of the page.

--- userdoc:hosted_guest_vm_linode [2018/05/29 17:21]
abelbeck
+++ userdoc:hosted_guest_vm_linode [2018/05/30 07:25]
abelbeck
@@ Line 40: / Line 40: @@
 {{:userdoc:hosted_guest_vm_linode-lassie.jpeg?nolink|Lassie}}
-We mention this since your AstLinux "reboot" will only act as a "poweroff" if Lassie is disabled. As such you will only be asked to "Reboot" to run a configuration profile.
+We mention this since your AstLinux "reboot" will only act as a "poweroff" if Lassie is disabled.
 OK, let's begin ...
 Using the Linodes -> Dashboard tab,
-create an installer disk (120 MB) and a boot disk (8000 MB), both of type "unformatted / raw".
+create an installer disk (200 MB) and a boot disk (8000 MB), both of type "unformatted / raw".
 {{:userdoc:hosted_guest_vm_linode_create-installer-disk.jpeg?nolink|Create Installer Disk}}
@@ Line 55: / Line 55: @@
 Installer Profile:
+!!Tip ->!! Don't miss the boot device is ''/dev/sdb''
 {{:userdoc:hosted_guest_vm_linode_installer-config.jpeg?nolink|Installer Config}}
@@ Line 88: / Line 90: @@
 Select the "Install" installer menu, follow the dialogs to install an AstLinux image to your virtual disk.
+When finished **do not** select the “Shutdown” installer menu, if you did Linode's Lassie would just restart it.
 {{:userdoc:hosted_guest_vm_linode_dashboard.jpeg?nolink|Dashboard}}