Differences

This shows you the differences between two versions of the page.

--- userdoc:guest_vm_xenserver [2016/03/12 10:29]
abelbeck
+++ userdoc:guest_vm_xenserver [2016/03/12 11:31]
abelbeck
@@ Line 48: / Line 48: @@
 {{:userdoc:vm_xenserver-toolbar.jpeg?nolink|Toolbar}}
+Follow the prompts for adding a new server and password management.
 {{:userdoc:vm_xenserver-add-new-server.jpeg?nolink|Add New Server}}
@@ Line 77: / Line 79: @@
 {{:userdoc:vm_xenserver-cpu-memory.jpeg?nolink|CPU and Memory}}
+Click "Properties" if you want to increase the disk size over 10 GB, usually just click "Next"...
 {{:userdoc:vm_xenserver-storage.jpeg?nolink|Storage}}
+Click "Properties" if you want to specify the MAC address, usually just click "Next"...
 {{:userdoc:vm_xenserver-networking.jpeg?nolink|Networking}}
+The next dialog displays a summary of your VM, for this example uncheck "Start the new VM automatically", then click "Create Now"...
 {{:userdoc:vm_xenserver-finish.jpeg?nolink|Finish}}
+Start your new VM by selecting "AstLinux" on the left, click the "Console" tab, then click "Click here to start it."...
 {{:userdoc:vm_xenserver-click-here-to-start.jpeg?nolink|Click Here to Start}}
+After a few seconds you should see the AstLinux Installer:
 {{:userdoc:vm_xenserver-install.jpeg?nolink|Install}}
+Select the “Install” installer menu, follow the dialogs to install an AstLinux image to your virtual disk.
+When finished select the “Shutdown” installer menu.
-{{:userdoc:vm_xenserver-reboot.jpeg?nolink|Reboot}}
+Next, click on "Eject" to remove the virtual DVD drive:
+{{:userdoc:vm_xenserver-eject.jpeg?nolink|Eject}}
+Boot into AstLinux by clicking "Click here to start it."...
 {{:userdoc:vm_xenserver-astlinux-finish.jpeg?nolink|Astlinux Finish}}
+Finally, configure AstLinux using the normal **[[userdoc:new-install|setup]]**.
+!!Tip ->!! Note the "IPv4 Address:" on the screen and access the VM with SSH or an HTTPS browser on the same network.