Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
userdoc:guest_vm_xenserver [2016/03/12 10:42] abelbeck |
userdoc:guest_vm_xenserver [2016/03/12 10:55] abelbeck |
||
---|---|---|---|
Line 89: | Line 89: | ||
{{: | {{: | ||
+ | Start your new VM by selecting " | ||
{{: | {{: | ||
+ | After a few seconds you should see the AstLinux Installer: | ||
{{: | {{: | ||
+ | Select the “Install” installer menu, follow the dialogs to install an AstLinux image to your virtual disk. | ||
+ | When finished select the “Reboot” installer menu. | ||
{{: | {{: | ||
+ | Since the default boot order is to boot off the Hard disk, a “Reboot” will automatically boot into AstLinux: | ||
{{: | {{: | ||
+ | |||
+ | Finally, configure AstLinux using the normal **[[userdoc: | ||
+ | |||
+ | !!Tip ->!! Note the "IPv4 Address:" | ||
+ |