Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
userdoc:guest_vm_xenserver [2016/03/12 10:29] abelbeck |
userdoc:guest_vm_xenserver [2016/03/12 10:55] abelbeck |
{{:userdoc:vm_xenserver-cpu-memory.jpeg?nolink|CPU and Memory}} | {{:userdoc:vm_xenserver-cpu-memory.jpeg?nolink|CPU and Memory}} |
| |
| Click "Properties" if you want to increase the disk size over 10 GB, usually just click "Next"... |
| |
{{:userdoc:vm_xenserver-storage.jpeg?nolink|Storage}} | {{:userdoc:vm_xenserver-storage.jpeg?nolink|Storage}} |
| |
| Click "Properties" if you want to specify the MAC address, usually just click "Next"... |
| |
{{:userdoc:vm_xenserver-networking.jpeg?nolink|Networking}} | {{:userdoc:vm_xenserver-networking.jpeg?nolink|Networking}} |
| |
| The next dialog displays a summary of your VM, for this example uncheck "Start the new VM automatically", then click "Create Now"... |
| |
{{:userdoc:vm_xenserver-finish.jpeg?nolink|Finish}} | {{:userdoc:vm_xenserver-finish.jpeg?nolink|Finish}} |
| |
| Start your new VM by selecting "AstLinux" on the left, click the "Console" tab, then click "Click here to start it."... |
| |
{{:userdoc:vm_xenserver-click-here-to-start.jpeg?nolink|Click Here to Start}} | {{:userdoc:vm_xenserver-click-here-to-start.jpeg?nolink|Click Here to Start}} |
| |
| After a few seconds you should see the AstLinux Installer: |
| |
{{:userdoc:vm_xenserver-install.jpeg?nolink|Install}} | {{:userdoc:vm_xenserver-install.jpeg?nolink|Install}} |
| |
| Select the “Install” installer menu, follow the dialogs to install an AstLinux image to your virtual disk. |
| When finished select the “Reboot” installer menu. |
| |
{{:userdoc:vm_xenserver-reboot.jpeg?nolink|Reboot}} | {{:userdoc:vm_xenserver-reboot.jpeg?nolink|Reboot}} |
| |
| Since the default boot order is to boot off the Hard disk, a “Reboot” will automatically boot into AstLinux: |
| |
{{:userdoc:vm_xenserver-astlinux-finish.jpeg?nolink|Astlinux Finish}} | {{:userdoc:vm_xenserver-astlinux-finish.jpeg?nolink|Astlinux Finish}} |
| |
| Finally, configure AstLinux using the normal **[[userdoc:new-install|setup]]**. |
| |
| !!Tip ->!! Note the "IPv4 Address:" on the screen and access the VM with SSH or an HTTPS browser on the same network. |
| |